Island Hopper Kayak Conventional Transom Trolling Motors for Pelican Kayaks without Rudder System
Including Pelican Catch 110 & Pelican Catch 120 Kayaks
|
Conventional Trolling Motors are the most commonly used motor for boating and kayaking. They are cost affective and are equipped with 5 forward / 2 reverse speeds. They are primarily designed to propel you quickly to your desired destination or fishing hole, and then reposition your boat or kayak when currents or wind blow you off course.
Understanding Conventional Speeds: - 1st and 2nd speeds are designed for “short bursts” only, not to exceed 15 minutes intervals at a time. "Not for trolling", as it will damage these two speeds. - 3rd speed is for covering larger areas, traveling and mostly getting around while conserving battery. - 4th speed is for traveling longer distances faster. - 5th speed is for when speed is required, such as a change in the weather, current, chop waters or an emergency; getting to safety or shore quickly. Battery Compatibility: Deep Cycle Marine, AGM and GEL batteries. Conventional trolling motors are Not compatible with Lithium-Ion / LiFePO4 batteries |
Navigate Pelican Kayaks with Included Telescoping Steering Handle - Pelican Catch 100, 110, 120 & 130 Kayaks
|
Transom Mount Conventional Trolling Motor - Navigate with Steering Handle
Item # 24-7761 Includes conventional trolling motor with customized mounting bracket, remote controller with 5 speeds forward and 3 speeds reverse, telescoping steering handle, motor lifting cord kit, and all stainless steel hardware required for installation. Zinc anode on salt water models only. No access hatch required. Battery Type: Deep Cycle Marine, AGM & Gel Batteries Only Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately). |
|
|
Transom Mount Conventional Trolling Motor w/ 35ah AGM Battery- Navigate with Steering Handle
Item # 24-2214 Includes conventional trolling motor with customized mounting bracket, remote controller with 5 speeds forward and 3 speeds reverse, telescoping steering handle, motor lifting cord kit, 35ah AGM battery, and all stainless steel hardware required for installation. Zinc anode on salt water models only. Battery Type: Deep Cycle Marine, AGM & Gel Batteries Only Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately). No access hatch required. |
|
|
Coast Guard requirements dictate that each ungrounded current-carrying conductor must be protected by a manually reset, trip-free circuit breaker or fuse.
|
Trolling motors require a 12v battery to operate. Depending on the pounds of thrust of the motor you choose, you may require a back up battery for longer range use. Battery range will vary due to size, weight and type of kayak in addition to kayaks load, wind and current. *Additional battery info Click Here
|
Customers Who Bought This Item Also Bought
|
Item # 33-4567
Mounting Bracket for Remote Control Mounts to kayak, allows remote control to pivot for ease of use. Includes two stainless steel self-tapping screws. This item can only be ordered when ordering any transom trolling kits. |
Sale Price $12.99
|
|
Item # 33-4509
Cord Guide for Lift Kit Cord Cord bracket guide mounts to kayak, assists the lift cord by keeping the cord in place. Includes two stainless steel self-tapping screws. |
Sale Price $7.99
|
|
Item # 33-0000
Propellers for 30lbs, 32lbs, 46lbs, 55lbs 56lbs, Thrust Trolling Motor for Island Hopper Trolling Motors Only |
|
 |
Item # 83699
35ah AGM Battery 12volt Compact 35ah AGM seal battery fit neatly on kayaks, low profile allowing for more space to store other items aboard Approx. size: 9" x 8" x 6" (may vary slightly by 1" on all side) Trolling motors require a 12v battery to operate. Depending on the pounds of thrust of the motor you choose, you may require a back up battery for longer range use. Battery range will vary due to size, weight and type of kayak in addition to kayaks load, wind and current. *Additional battery info Click Here |
Sale Price $89.99
|
Lifting and lowering of trolling motor is as easy 1, 2, 3 . . . |
Transom Mount with Steering Handle Kits
Easy installation transom mount kits that are dependable and will fit new and older kayaks without rudders or foot pedals. Transom Mount trolling motors can be installed with a traditional surface set up and steering handle. Transom motor mount has been engineered to attach to a kayak with four stainless screws, eliminating any cut outs to the hull and any access hatches. No unsightly wires, just two flexible cables: one to the remote control box and one to the battery terminals. The motor and shaft are low in profile and compact in size making it easy for removal and storage.
Easy installation transom mount kits that are dependable and will fit new and older kayaks without rudders or foot pedals. Transom Mount trolling motors can be installed with a traditional surface set up and steering handle. Transom motor mount has been engineered to attach to a kayak with four stainless screws, eliminating any cut outs to the hull and any access hatches. No unsightly wires, just two flexible cables: one to the remote control box and one to the battery terminals. The motor and shaft are low in profile and compact in size making it easy for removal and storage.
Lifting Feature Allows the Lifting of Motor
All transom mounts tend to trail lower than the keel of the kayak making it difficult to navigate in weeded waters, where sea grass, lily pods and debris is floating, as well as, running a ground, beach casting and landing and during portage. To resolve this issue we added a remote lifting feature to lift the motor while, sitting in your kayak and clear obstacles.
All transom mounts tend to trail lower than the keel of the kayak making it difficult to navigate in weeded waters, where sea grass, lily pods and debris is floating, as well as, running a ground, beach casting and landing and during portage. To resolve this issue we added a remote lifting feature to lift the motor while, sitting in your kayak and clear obstacles.
Telescoping Steering Handle
Our system allows the kayak to steer using the telescoping handle. The steering handle is adjustable to meet the different kayak lengths. No altering of cables or kayak. The transom mounts are made from durable polypropylene composite for marine application, aluminum and stainless steel hardware. We provide stainless steel fasteners to prevent rust.
Our system allows the kayak to steer using the telescoping handle. The steering handle is adjustable to meet the different kayak lengths. No altering of cables or kayak. The transom mounts are made from durable polypropylene composite for marine application, aluminum and stainless steel hardware. We provide stainless steel fasteners to prevent rust.
Fresh & Saltwater Trolling Motors, 32 lbs, 46 lbs, 55 lbs Thrust of Power Available
We offer several models for fresh water and salt water use, and the Remote Controllers are IP54 and Trolling Motors are IP64: Splash Proof, Not Submersible
We offer several models for fresh water and salt water use, and the Remote Controllers are IP54 and Trolling Motors are IP64: Splash Proof, Not Submersible
*Speeds: 5 Speeds Forward / 3 Speeds Reverse, Three Bade Propeller
The motors have a selectors switch, 1-5 speeds forward and 3 reverse. The three blade machete propeller is included with 55lbs trolling motors. The two blade machete propeller are included with 46lbs and 32lb trolling motors. The machete propeller allows for more torque to push the kayak forward in choppy waters or windy conditions, in addition, to cut through weeds and debris with minimal fouling. Remote Controllers are IP54 and Trolling Motor are IP64: Splash Proof, Not Submersible.
The motors have a selectors switch, 1-5 speeds forward and 3 reverse. The three blade machete propeller is included with 55lbs trolling motors. The two blade machete propeller are included with 46lbs and 32lb trolling motors. The machete propeller allows for more torque to push the kayak forward in choppy waters or windy conditions, in addition, to cut through weeds and debris with minimal fouling. Remote Controllers are IP54 and Trolling Motor are IP64: Splash Proof, Not Submersible.
Pelican Catch110 & Catch120 Kayak Transom Trolling Motors
Our Transom Power Drive System Are Guaranteed
For sales and technical support, call (727) 501-3116
|
Battery Disclaimer Island Hopper Outboards is not responsible for the performance of any battery range. It is the sole responsibility of the consumer to choose the right battery and/or batteries.
|