Kayak Trolling Motors for Hobie Kayaks & Kayak Trolling Motor Mounts For All Hobie Kayaks
  • Kayaks by Brand
  • Kayak Transom Motors
  • Kayak Trolling Motor Mount
  • Power Pole Transom Motor
  • Hobie SpotLock Trolling Motors
  • Motors For 3 Waters Kayaks
  • Battery & Charger
  • Kayak Gas Motor Kit
  • Kayak Trolling Motors
  • DIY Kayak Transom Kits
  • LiFeP04
  • Gallery
  • Parts
    • Spare & Replacement Parts
    • Kayak Outriggers & Leaning Post
Picture
Conventional Kayak Trolling Motors Transom Mounting ​for Jackson Kayaks 
​Fits Big Tuna, Big Rig, Bite Angler, Coosa, Cuda, Kilroy, Liska and Mayfly Kayaks
Picture
Transom mount kits install quick and easily, are dependable and will fit new and older Jackson kayaks without rudders or foot pedals.  No unsightly wires, just two flexible cables: one to remote control box and one to battery terminals.  ​The motor and shaft are low in profile and compact in size making it easy for removal and storage.
​Conventional Transom Trolling Motors for Jackson Kayaks
​Item # 99-7761
Choose Thrust from Menu
Must Choose Navigate Kayak Option
Year, Make & Model of Kayak
Please Provide Telephone #
Navigate with Steering Handle or Kayaks Rudder Cable   Item # 99-7761
Includes conventional trolling motor with customized mounting bracket, remote controller with 5 speeds forward and 3 speeds reverse, motor lifting cord kit, and all stainless steel hardware required for installation.  Trolling motors are sealed unbreakable shaft, 12 volts, available in Freshwater (FW) and Salt Water (SW), 32lbs, 46lbs and 55lbs of thrust. Zinc anode on salt water models only.
​

Note:  For kayaks without a rudder system, you must order with Navigate w/ Steering Handle Option

Note:  For kayaks with rudder system,  you will remove rudder, but leave cables in place, and order Navigate w/ Kayaks Rudder Cables Option


​Battery Type:  Deep Cycle Marine, AGM & Gel Batteries Only
Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately).   No access hatch required. 
​
​Coast Guard requirements dictate that each ungrounded current-carrying conductor must be protected by a manually reset, trip-free circuit breaker or fuse.
Trolling motors require a 12v battery to operate.  Depending on the pounds of thrust of the motor you choose,  you may require a back up battery for longer range use.  
​
​
Battery range will vary due to size, weight and type of  kayak in addition to kayaks load, wind and current.  *Additional battery info
 Click Here

Items Purchased Along with Trolling Motors
Add a AGM Battery + Charger + Fuse From Menu
Please Provide Telephone #
Battery & Charger  Item # 88-4324
35ah AGM Battery & Battery Charger - 12volt    Approx. size: 9" x 8" x 6" (may vary slightly by  1" on all side) Trolling motors require a 12v battery to operate. Depending on the pounds of thrust of the motor you choose, you may require a back up battery for longer range use. Battery range will vary due to size, weight and type of kayak in addition to kayaks load, wind and current. Battery charge for charging AGM & deep cycle batteries.  *Additional battery info Read More
Auto Reset Fuse 
Protect your investment with an high quality auto reset fuse circuit breaker. High quality reset circuit breaker.  Stops power surges from damaging your amps, protects your trolling motor from electrical damage. Fuse will be installed onto trolling motor when ordered with trolling motor​. Read More

Picture
Auto Reset Fuse    Item # 33-8765
Protect your investment with an high quality auto reset fuse circuit breaker. High quality reset circuit breaker.  Stops power surges from damaging your amps, protects your trolling motor from electrical damage. Fuse will be installed onto trolling motor when ordered with a trolling motor. **Coast Guard requirements dictate that each ungrounded current-carrying conductor must be protected by a manually reset, trip-free circuit breaker or fuse.  Read More

Picture
Item # 33-4567
Mounting Bracket for Remote Control
​
Mounts to kayak, allows remote control to pivot for ease of use. Includes two stainless steel self-tapping screws. 
 This item can only be ordered when ordering any transom trolling kits.
Sale Price $12.99

Picture
Item # 33-4509
Cord Guide for Lift Kit Cord
Cord bracket guide mounts to kayak, assists the lift cord by keeping the cord in place. Includes two stainless steel self-tapping screws. 
Sale Price  $7.99

Picture
Item # 33-0000
Propeller
​Propellers  for 30lbs, 32lbs, 46lbs, 55lbs 56lbs, Thrust.  For Island Hopper Trolling Motors Only


Choose Propeller Size

Understanding Lithium-Ion (LiFePO4) Battery & Their Effect On Conventional Trolling Motors vs Trolling Motors with Intergraded Circuit Board
LiFePO4 batteries were designed to be light weight and pack more energy.  LiFePO4 batteries were engineered to store as much voltage from solar panels. 
The stored voltage is unregulated and will burnout conventional trolling motors or shorten their lifespan, because the collected volts are too high (+18 volts =
12.8 - 16.0 volts DC), whereas conventional trolling motors operate on regulated 12 volts.  Therefore, to regulate the LiFePO4 batteries voltage output, a trolling motor requires an intergraded circuit board to control speed and regulate the voltage, along with a heavy gauged battery cable, lithium-ion plug and an auto reset fuse.
 T
rolling motors with intergraded circuit board ​tend to have a longer lifespan and extended fishing time while kayaking.   Read More
​Conventional Trolling Motors are the most commonly used motor for boating and kayaking. They are cost affective and are equipped with 5 forward / 2 reverse speeds. They are primarily designed to propel you quickly to your desired destination or fishing hole, and then reposition your boat or kayak when currents or wind blow you off course.  
Understanding Conventional Speeds:
- 1st and 2nd speeds are designed for “short bursts” only, not to exceed 15 minutes intervals at a time. "Not for trolling", as it will damage these two speeds.  
- 3rd speed is for covering larger areas, traveling and mostly getting around while conserving battery.  
- 4th speed is for traveling longer distances faster.
- 5th speed is for when speed is required, such as a change in the weather, current, chop waters or an emergency; getting to safety or shore quickly.

Battery Compatibility:  Deep Cycle Marine, AGM and GEL batteries.  Conventional trolling motors are  Not compatible  with Lithium-Ion / LiFePO4 batteries                         

Doulbe Click Video to Play

Transom Mount with Steering Handle Kits
Easy installation transom mount kits that are dependable and will fit new and older  Jackson kayaks without rudders or foot pedals. Transom Mount trolling motors can be installed with a traditional surface set up and steering handle. Transom motor mount has been engineered to attach to a kayak with four stainless screws, eliminating any cut outs to the hull and any access hatches.  No unsightly wires, just two flexible cables: one to the remote control box and one to the battery terminals. The motor and shaft are low in profile and compact in size making it easy for removal and storage
Lifting Feature Allows the Lifting of Motor
All transom mounts tend to trail lower than the keel of the kayak making it difficult to navigate in weeded waters, where sea grass, lily pods and debris is floating, as well as, running a ground, beach casting and landing and during portage. To resolve this issue we added a remote assist lifting feature to lift the motor while, sitting in your kayak and clear obstacles.
​Telescoping Steering Handle
Our system allows the kayak to steer using the telescoping handle.  The steering handle is adjustable to meet the different kayak lengths.  No altering of cables or kayak.  The transom mounts are made from durable polypropylene composite for marine application, aluminum and stainless steel hardware.  Stainless steel fasteners are provided to prevent rust. 
Fresh & Saltwater Trolling Motors, 32 lbs, 46 lbs, 55 lbs Thrust of Power Available
We offer several models for fresh water and salt water use, and the Remote Controllers are IP54 and Trolling Motors are IP64: Splash Proof, Not Submersible   
*Speeds: 5 Speeds Forward / 3 Speeds Reverse, Three Bade Propeller
The motors have a selectors switch, 1-5 speeds forward and 3 reverse. The three blade machete propeller is included with 55lbs trolling motors. The two blade machete propeller are included with 46lbs and ​32lb trolling motors. The machete propeller allows for more torque to push the kayak forward in choppy waters or windy conditions, in addition, to cut through weeds and debris with minimal fouling. Remote Controllers are IP54: Splash Proof, Not Submersible.
Picture
Island Hopper 55# Transom Mount on a Jackson Big Rig

Our Transon Power Drive System is Guaranteed

For sales and technical support, call (727) 501-3116

Jackson Fishing Kayak Transom Motors, Big Rig, Mayfly, Bite

Remote Controllers are IP54 and Trolling Motors are IP64: Splash Proof, Not Submersible.

Picture
Battery Disclaimer  Island Hopper Outboards is not responsible for the performance of any battery range. It is the sole responsibility of the consumer to choose the right battery and/or batteries. 
Product Reviews     Policy and Warranty    Contact Us
© Copyright 2023 Island Hopper Outboards
  • Kayaks by Brand
  • Kayak Transom Motors
  • Kayak Trolling Motor Mount
  • Power Pole Transom Motor
  • Hobie SpotLock Trolling Motors
  • Motors For 3 Waters Kayaks
  • Battery & Charger
  • Kayak Gas Motor Kit
  • Kayak Trolling Motors
  • DIY Kayak Transom Kits
  • LiFeP04
  • Gallery
  • Parts
    • Spare & Replacement Parts
    • Kayak Outriggers & Leaning Post