Kayak Trolling Motors for Hobie Kayaks & Kayak Trolling Motor Mounts For All Hobie Kayaks
  • Kayaks by Brand
  • Kayak Transom Motors
  • Kayak Trolling Motors
  • Kayak Trolling Motor Mount
  • Power Pole Transom Motor
  • Gallery
  • Kayak Outriggers & Leaning Post
  • Battery & Charger
  • Kayak Gas Motor Kit
  • DIY Kayak Transom Kits
  • LiFeP04
  • Accessories
  • Home
Picture
Island Hopper Kayak Transom Motors for Ascend Kayaks
 Navigate with Foot Pedals OR Navigate with Steering Handle
​Transom Mount Fit Ascend Kayak Models: 
Sit In Ascends:  FS12T, FS10T, D10T  and  Sit On Top  Ascends:  FS128T, D10, FS10, H12
Picture

Conventional Transom Trolling Motor Mount Kits - Navigate with Steering Handle

Picture
Transom Mount Conventional Trolling Motor - Navigate with Steering Handle
Item # 77-7761
Includes conventional trolling motor with customized mounting bracket, remote controller with 5 speeds forward and 3 speeds reverse, telescoping steering handle, motor lifting cord kit, and all stainless steel hardware required for installation.  Zinc anode on salt water models only. 
​Battery Type:  Deep Cycle Marine, AGM & Gel Batteries Only
​
 Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately).   No access hatch required. 
​

Transom Steering Handle Mount Choose Trolling Motor Below
Year & Model of Ascend Kayak
Please Provide Telephone #

Picture
Transom Mount Conventional Trolling Motor w/ 35ah AGM Battery- Navigate with Steering Handle
Item # 77-2214
Includes conventional trolling motor with customized mounting bracket, remote controller with 5 speeds forward and 3 speeds reverse, telescoping steering handle, motor lifting cord kit, 35ah AGM battery, and all stainless steel hardware required for installation.  Zinc anode on salt water models only. 
​Battery Type:  Deep Cycle Marine, AGM & Gel Batteries Only
Note:  Remote control is hand held. (Optional Mounting Bracket Sold Separately).    No access hatch required. 
​

Transom Steering Handle Mount + Battery Choose Motor Below
Year & Model of Ascend Kayak
Please Provide Telephone #
**Coast Guard requirements dictate that each ungrounded current-carrying conductor must be protected by a manually reset, trip-free circuit breaker or fuse.

Conventional Transom Mount Kits - Navigate with Foot Pedal - Rudder Cables Required


Picture
Transom Mount Conventional Trolling Motor - Navigate with Foot Pedals
Item # 77-2500

Includes conventional trolling motor with customized mounting bracket, remote controller with 5 speeds forward and 3 speeds reverse, motor lifting cord kit, and all stainless steel hardware required for installation.  Zinc anode on salt water models only. 
​
Attaches to Rudder Cables for Navigating with Foot Pedals
​Battery Type:  Deep Cycle Marine, AGM & Gel Batteries Only
Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately).   No access hatch required. 

Transom Surface Mount - Choose Trolling Motor Below
Year & Model of Ascend Kayak
Please Provide Telephone #

Picture
Transom Mount Conventional Trolling Motor w/ 35 AGM Sealed Battery - Navigate with Foot Pedal
Item # 77-2521

Includes conventional trolling motor with customized mounting bracket, remote controller with 5 speeds forward and 3 speeds reverse, motor lifting cord kit, 35ah AGM battery and all stainless steel hardware required for installation.  Zinc anode on salt water models only.  Attaches to Rudder Cables for Navigating with Foot Pedals
​
​Battery Type:  Deep Cycle Marine, AGM & Gel Batteries Only
Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately).     No access hatch required. 

Transom Surface Mount + Battery - Choose Trolling Motor Below
Year & Model of Ascend Kayak
Please Provide Telephone #
**Coast Guard requirements dictate that each ungrounded current-carrying conductor must be protected by a manually reset, trip-free circuit breaker or fuse**
Picture
Ascend Transom Motor 55lb Thrust

Variable Speed Transom Trolling Motor Mount Kits 

Picture
Transom Variable Speed Trolling Motor  - Navigate w/ Steering Handle
Item # 77-07761-VS-LITH
Includes variable speed trolling motor with intergraded circuit board, customized mounting bracket, handheld remote with infinite forward and reverse speed, heavy gauged battery cable, lithium ion plug, telescoping steering handle, motor lifting cord kit and all stainless steel hardware required for installation.  
Zinc anode on salt water models only. 
Battery Type:  LiFeP04, 
Deep Cycle Marine, AGM & Gel Batteries
​Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately) (See Below)

Variable Speed Transom Mount Kit Steering Handle Choose A Motor
Year, Make & Model of Kayak
Please Provide Telephone #

Picture
Transom Variable Speed Trolling Motor -  Navigate with Foot Pedal
Item # 77-02500-VS-LITH
Includes trolling motor with intergraded circuit board, customized mounting bracket, handheld remote with infinite forward and reverse speed, heavy gauged battery cable, lithium ion plug, motor lifting cord kit and all stainless steel hardware required for installation.  Zinc anode on salt water models only.   ​Attaches to Rudder Cables for Navigating with Foot Pedals
​ Battery Type:  LiFeP04 Deep, Cycle Marine, AGM & Gel Batteries
​Note: Remote control is hand held. (Optional Mounting Bracket Sold Separately) (See Below)

Variable Speed Transom Mount Kit Rudder Mount - Choose A Motor
Year, Make & Model of Kayak
Please Provide Telephone #
Picture
Ascend Transom Motors 46lbs Thrust

Kayak Motors ​-​ Ascend Kayaks 128T, D10, FS10, H12,​ ​12T,​ ​10T


Understanding Lithium-Ion (LiFePO4) Battery & Their Effect On Conventional Trolling Motors vs Trolling Motors with Intergraded Circuit Board
LiFePO4 batteries were designed to be light weight and pack more energy.  LiFePO4 batteries were engineered to store as much voltage from solar panels. 
The stored voltage is unregulated and will burnout conventional trolling motors or shorten their lifespan, because the collected volts are too high (+18 volts =
12.8 - 16.0 volts DC), whereas conventional trolling motors operate on regulated 12 volts.  Therefore, to regulate the LiFePO4 batteries voltage output, a trolling motor requires an intergraded circuit board to control speed and regulate the voltage, along with a heavy gauged battery cable, lithium-ion plug and an auto reset fuse.
 T
rolling motors with intergraded circuit board ​tend to have a longer lifespan and extended fishing time while kayaking.   Read More
​Conventional Trolling Motors are the most commonly used motor for boating and kayaking. They are cost affective and are equipped with 5 forward / 2 reverse speeds. They are primarily designed to propel you quickly to your desired destination or fishing hole, and then reposition your boat or kayak when currents or wind blow you off course.  
Understanding Conventional Speeds:
- 1st and 2nd speeds are designed for “short bursts” only, not to exceed 15 minutes intervals at a time. "Not for trolling", as it will damage these two speeds.  
- 3rd speed is for covering larger areas, traveling and mostly getting around while conserving battery.  
- 4th speed is for traveling longer distances faster.
- 5th speed is for when speed is required, such as a change in the weather, current, chop waters or an emergency; getting to safety or shore quickly.

Battery Compatibility:  Deep Cycle Marine, AGM and GEL batteries.  Conventional trolling motors are  Not compatible  with Lithium-Ion / LiFePO4 batteries                         
Variable Speed Trolling Motors are one of the most improved technology today. Boaters and kayakers are gravitating to trolling motors with variable speeds due to their many benefits,
Benefits of Variable Speed Include:
- Infinite Speed Range of "0-100 speed forward and reverse", which allows for trolling at very low speeds for hours without affecting any speeds of the motor. 
- A Micro Processer aka (Pulse Width Modulator) to increase battery range 3 to 4 times, allowing for hours of continuous trolling.
- Controlled Amperage provides steady trolling in currents and wind while conserving battery at 95% efficiency.
- Integrated Electronic Board System senses over and undercharge of voltage, eliminates voltage spikes, 95% efficiency in power and torque.
- Soft start: no spooking of fish while trolling and lighter in weight than conventional trolling motors,
​Battery Compatible:  Lithium-Ion / LiFePO4, Deep Cycle Marine, AGM and GEL batteries.
Lithium Iron - LiFeP04 Compatible Trolling Motors - For LiFeP04 Battery Use​
These motors are designed to be used with LiFeP04 battery and built with an intergraded circuit board which regulates the voltage and allows speed adjustments in fractional increments, from 1/4 to 5 mph. This motor includes heavy gauged wire, auto reset fuse, lithium-ion plug, which handles 60 to 200 amp LiFePO4 batteries.
Customers Who Bought This Item Also Bought
Picture
Item # 33-4567
Mounting Bracket for Remote Control
​
Mounts to kayak, allows remote control to pivot for ease of use. Includes two stainless steel self-tapping screws. 
 This item can only be ordered when ordering any transom trolling kits.
Sale Price  $12.99

Picture
 Item # 33-8765
Auto Reset Fuse - Protect your investment with an high quality auto reset fuse circuit breaker. High quality reset circuit breaker.  Stops power surges from damaging your amps, protects your trolling motor from electrical damage. Fuse will be installed onto trolling motor when ordered with a trolling motor.  Read More
Sale Price  $12.99

Picture
Item # 33-4509
Cord Guide for Lift Kit Cord​ - Cord bracket guide mounts to kayak, assists the lift cord by keeping the cord in place. Includes two stainlesssteel self-tapping screws. 
Sale Price  $7.99

Picture
Item # 33-0000
Propeller - Propellers  for 30lbs, 32lbs, 46lbs, 55lbs 56lbs, Thrust.  Keep a spare propeller on board for safety. For Island Hopper Trolling Motors Only
Choose Propeller Size

Picture
Item # 83699
35ah  AGM Battery  - 12 volt  Approx. size: 9" x 8" x 6" ​(may vary slightly by 1" on all side.  For more information, Click Here
Sale Price $89.99

Picture
Item # 88-4324
35ah AGM Sealed  Battery & Battery Charger.  
For more information, Click Here
Sale Price $154.99

Picture
Picture
Picture
Picture
Picture

Double Click Video to Play - Lifting and lowering of trolling motor is as easy 1, 2, 3 . . .

Navigating with Steering Handle
Navigating with Katays Rudder Cables

For sales and technical support, call (727) 501-3116

Trolling motors require a 12v battery to operate.  Depending on the pounds of thrust of the motor you choose,  you may require a back up battery for longer range use.    
Battery range will vary due to size, weight and type of  kayak in addition to kayaks load, wind and current.  Additional battery info click here
Remote Controllers are IP54 and Trolling Motors are IP64: Splash Proof, Not Submersible.

Picture
Battery Disclaimer  Island Hopper Outboards is not responsible for the performance of any battery range. It is the sole responsibility of the consumer to choose the right battery and/or batteries. 
Product Reviews     Policy and Warranty    Contact Us
© Copyright 2021 Island Hopper Outboards
  • Kayaks by Brand
  • Kayak Transom Motors
  • Kayak Trolling Motors
  • Kayak Trolling Motor Mount
  • Power Pole Transom Motor
  • Gallery
  • Kayak Outriggers & Leaning Post
  • Battery & Charger
  • Kayak Gas Motor Kit
  • DIY Kayak Transom Kits
  • LiFeP04
  • Accessories
  • Home